Filter
Top Products
P
REPARATION FOR USE
7
EN
CONNECTION
This section describes how to connect this TV to reception and other sources.
[ANTENNA / BASIC CABLE CONNECTION]
1) When connecting TV to antenna
Connect the coaxial cable on your home outlet to the ANT. IN jack of this TV.
2) When connecting
TV to basic cable (without box)
Connect the coaxial cable on your home outlet to the ANT. IN jack of this TV.
*Once connections are completed, turn on the TV and begin initial setup.
Channel scanning is necessary for the TV to memorize all available channels in your area. (Refer to
“INITIAL SETTINGS” on page 13.)
NOTES:
• For your safety and to avoid damages to the unit, unplug the coaxial cable from the ANT. IN jack before moving the unit.
• If you use an antenna in order to receive analog TV, the same antenna generally will work for DTV reception.
Outdoor or attic antennas will be more effective than set-top versions.
• Some cable channels cannot be viewed when the TV is connected to an aerial antenna because DTV program does not cover all
cable channels.You can watch them by switching to the cable connected to CATV.
• To easily switch between antenna and cable wires, you can purchase an “Antenna Selector” commercially available.
ANT. IN
VIDE
O
L
R
L
R
AUDIO
INPUT
Cb
Cr
S-VIDEO
VHF / UHF
antenna
Coaxial cable
(not included)
Coaxial cable
(not included)
Rear of this TV
Cable TV
company
or
DIGI
T
AL
T
T
A
U
DIO OUTPUT
Y
V
IDE
O
-1 INP
UT
MAKE SURE YOU HAVE AN ANTENNA.
As DTV is only available over the air, you need an antenna to receive a digital signal.
CONTENTS / PREPARATION FOR USE