Filter
Top Products
48 EN
Checking, canceling, or correcting the timer
programming information
If the timer program did not complete correctly,
the error number appears in the timer pro-
gramming list.
1) Press [T-SET].
will disappear on the front panel display.
2) Press [TIMER PROG.].
3) Check the information on the list you want to edit.
Timer Programming
1/1
MON JAN/01 10:00AM2H (1:00)
JAN/ 2/07 12:00 AM 125-1 SP
Date Start End CH
JAN/02 12:00AM 1:00AM DTV125- 1
New Program
4-A) To delete the timer program:
1 Use [K / L] to select the program you want to
delete, then press [ENTER].
2 Use [K / L] to select “Delete”, then press
[ENTER].
Selection menu will appear.
3 Use [K / L] to select “Yes”, then press [ENTER].
4-B) To correct the timer program:
1 Use [K / L] to select the program you want to
correct, then press [ENTER].
2 Use [K / L] to select “Program Change”, then
press [ENTER].
3 Correct the timer program by using
[K / L / { / B], then press [ENTER].
5) Press [TIMER PROG.] to exit.
6) Press [T-SET] to return to the timer standby mode.
Timer Programming
1/1
TUE JAN/02 10:00AM
Date Start End CH
E41 JAN/02 12:00AM 1:00AM DTV125- 1
New Program
Each error number means:
E1-22
E37-39
Recording error other
than below
E35 PCA full *1
E23-24 Unrecordable disc E36 Already finalized
video format disc
E25-28
Copy prohibited program
E40 Some portion has
not been recorded
because of program
overlapping.
Recording did not
start at the start time.
E29 Disc protected
E30 Disc full
E31-32 Already 99 titles
recorded
E41 Power failed
E33 Already 999 chapters
recorded
E42
No disc when recording
E34 No space for Control
information
• A program with the error number is grayed in the timer
programming list.
• Once the timer programming list with error line(s) is
displayed, or after canceling and setting again the timer
standby mode, the program line(s) with error will be
cleared.
*1 PCA is a disc's space reserved for recording test.
Press [STOP C] to stop the disc recording or
[STOP C/EJECT A] to stop the cassette tape recording
on the front panel of the unit.
[STOP C] on the remote control is not effective.
Note
• Press [TIMER PROG.] to check the timer recording in
progress.
When the timer recording is proceeding, that
program will be highlighted with red. In this case,
you cannot select any other program.
To stop the timer recording in process
TIMER RECORDING