Filter
Top Products
38
OTHER FEATURES
Zero Search
The zero search feature enables the VCR to quickly return to a
counter reading of 0:00:00 anywhere on the tape. This is
especially convenient when you want to repeat a segment of the
tape several times.
1. Go to the beginning of the program you wish to return to.
2. Press INFO twice to display the time counter on the TV
screen.
3. Press CLEAR to reset the counter to 0:00:00.
4. Continue playing the tape.
5. Press STOP when you are ready to return to 0:00:00.
6. Press SEARCH on the remote twice to display the ZERO
SEARCH menu.
7. Press REVERSE (REV) to return to 0:00:00 on the tape.
ZERO SEARCH
Current tape counter is
2:17:25
Press REV to go to
0:00:00
Press SEARCH to exit
ZERO SEARCH
Searching for
0:00:00
Press STOP to cancel
Time Counter
The time counter shows the actual time it takes to record a program
or play back a segment of a recorded tape. It helps locate the
beginning or end of programs you taped. The time counter resets to
0:00:00 whenever the tape is ejected from the VCR.
For example, if you record a 30-minute program at the beginning of
the tape and you want to go to the end of that program to begin
another recording, you would:
1. Press INFO twice to display the time counter.
2. Press CLEAR to reset the time counter to 0:00:00.
3. Press FORWARD (FWD) to forward the tape until the time
counter reads 0:30:00.
4. Press STOP. This is the approximate end of the program. (You
may want to press PLAY to verify.) Now, you can begin
recording at this spot.
5. Press INFO to remove the time counter from the screen and
return to the normal display mode.
0:30:00
Hours
Minutes
Seconds