Filter
Top Products
8
How to Connect the Extender for HDMI 1.3 over one CAT6
1. Connect a HDMI cable (one is supplied) between the HDMI output on a
HDMI source device and the HDMI input on the Extender for HDMI 1.3 over
one CAT6 sending unit.
2. Connect a single CAT-6a cable between the sending and receiving units.
NOTE: When f eld terminating CAT-6a cabling please adhere to the TIA/EIA-
568-B specif cation. Please see page 11 for more information.
3. Connect a HDMI cable (user supplied) between the HDMI input on a HDMI
capable output device (i.e. HDMI display) and the HDMI output on the
Extender for HDMI 1.3 over one CAT6 receiving unit.
4. Connect the included 5V DC power supplies (two are included) between the
sending and receiving units and open wall power sockets.
5. Initialize the HDMI output device (i.e. HDMI display) f rst and the HDMI
source device last.
How to Equalize the Extender for HDMI 1.3 over one CAT6
The Extender for HDMI 1.3 over one CAT6 receiving unit has a equalization
Trim to compensate for the extension distance and the quality/skew variances that
are found in different CAT-6a cabling brands. If there is no output video or if output
video has video artifacting and/or video noise, please use the steps below to adjust
the equalization trimpot.
1. Insert a small f at head tool into the trimpot on the front panel of the
receiver unit.
2. The trimpot has 8 set positions. Turn the trimpot in a clockwise fashion until
it clicks into the next position. Continue adjusting the trimpot by trying all 8
positions until the issue is resolved.
3. Carefully remove the adjustment tool.
CONNECTING AND OPERATING THE EXTENDER