Filter
Top Products
9
DIP SWITCH CONFIGURATION
DIP SWITCH CONFIGURATION – DEEP COLOR
By default, Deep Color support is disabled (DIP #2 in the OFF position). If Deep
Color support is needed, you can change the position of one of the DIP switches
on the bottom of the receiver:
1. If the Receiver unit is currently being powered, please disconnect the power
adapter from the unit.
2. Turn the receiver unit upside down and locate the 4-DIP switch bank on
the bottom of the unit. NOTE: You may need to remove the piece of silver
colored metallic tape to expose the DIP switch bank.
3. Refer to the image below and locate DIP #2 on the DIP switch bank.
4. Move DIP 2 to the “ON” position. This will enable Deep Color support and
will be used only if the display supports this deep color. NOTE: DIP 1 must
be in the “OFF” position in order to enable deep color.
5. Reconnect power to the receiver unit.