Filter
Top Products
Congratulations on your purchase of the GefenTV Wireless for HDMI. Your complete satis-
faction is very important to us.
About Gefen
We specialize in total integration for your home theater, while also focusing on going above
and beyond customer expectations to ensure you get the most from your hardware. We
invite you to explore our distinct product line. Please visit http://www.gefen.com for the
latest offerings in High-Denition signal solutions or call us between the hours of 8:00 am
and 5:00 pm Monday-Friday, Pacic Standard Time for assistance with your A/V needs.
We’ll be happy to assist you.
The GefenTV Wireless for HDMI In-Room Solution
The GefenTV Wireless for HDMI In-Room Solution sends high denition audio and video to
any HDTV display up to 80 feet (25 meters). It extends HDMI A/V content from computers
using HDMI, set-top boxes, Blu-ray players, and other A/V sources to remote HDMI-
compliant display(s). This wireless product is comprised of a small Sender unit and one
table-top Receiver unit. It supports HD resolutions up to 1080p Full HD along with support
for up to 7.1 channels of LPCM, and up to 5.1 channels of Dolby® TrueHD, and DTS-HD
Master Audio™. The Wireless for HDMI In-Room Solution transmits within the room and
does not require line-of-sight placement of transceivers for good reception. Thanks to its
small form-factor and easy to plug in Sender unit, this product is ideal for high-denition
A/V extension within a conference room or home theater installation that requires the quick
addition of portable devices such as a presentation laptop computer or a video camera to
an existing A/V system. Additional features allow multiple Sender units where each display
can access up to eight sources, using the included handheld remote control.
How It Works
Plug the Sender unit directly into the HDMI output of the source. Connect the included
HDMI cable from the Receiver unit to the HDTV display. When using a PC as the source,
connect the supplied USB-to-mini-USB cable from the PC to the Sender unit. When using
sources that do not have an available powered USB port, you will need to use the
provided USB power supply. Connect the other power supply to the DC jack on the back
of the Receiver unit. Connect the power supplies to available electrical outlets. Power-up
the source and the display. Within approximately one minute, the “Video” indicators on both
units should now glow solid blue to indicate a successful connection between the Sender
and Receiver unit. If the Sender and Receiver units do not pair automatically, the LEDs
on the Sender will continue to blink. Navigate through the on-screen menu and have the
Receiver unit look for a Sender unit. If the remote is not available, you can press and hold
the recessed pairing button on the Receiver with a paper clip until its Link LED stops blink-
ing and goes dark. Press and hold the pairing button on the Sender unit until the Link LED
stops blinking and goes dark. If navigating the menu using the remote, press the OK button
on the IR remote. A message indicating that the Sender and the Receiver units have been
paired will appear on the display.
INTRODUCTION
1