Go-Video 9100 VCR User Manual


 
CHAPTER 5 - PLAYBACK FEATURES 25
Sequential & Loop Play
Two decks give you twice the playback features of a normal
VCR. Sequential Play allows you to insert tapes in both
decks and play one after another. Loop Play allows you to
play both tapes in a continuous loop.
To activate Sequential or Loop Play:
1 Insert tapes in both decks.
2 Press
MENU
until the DUAL-DECK FEATURES menu
appears.
3 Press “4” repeatedly to set PLAYBACK MODE to:
Norm - Tapes play normally.
Seq - (Sequential) Deck 1 plays to the end of the tape, then
Deck 2 plays to the end of the tape. If Auto Rewind is
set to on, both tapes will rewind automatically when
playback is finished.
Loop - Deck 1 plays to the end of the tape, then Deck 2
begins playing. While Deck 2 is playing, Deck 1
automatically rewinds to the beginning. When
playback is finished in Deck 2, Deck 1 plays again
and the process repeats in a continuous loop until
you press the
STOP
key. Rewinding is automatic
regardless of the Auto Rewind setting.
Automatic Tracking
Your Dual-Deck VCR is equipped with an Automatic Digital
Tracking System which is activated whenever you insert a
tape to play. While tracking is adjusted, you’ll see ATR
(Automatic Tracking) flash on the On-Screen Display.
If you need to adjust tracking manually:
1 Press the TRACKING & keys to move the
white streaks up or down and out of the picture. This
disables the ATR System.
2 To reactivate ATR, press the
ATR
key on the remote
control.
Set two tapes to play sequentially
or in a continuous loop.
What is Tracking?
Tracking adjusts the VCR’s heads
to fine tune playback. Your Dual-Deck
VCR has both automatic and manual
tracking.