Filter
Top Products
8 LF1600-INS-LAB-RevB07 • LF1600 Stand Assist
carriage bolt
kneepad assembly
kneepad side
support assembly
side support arm
flat washer
lock washer
acorn nut
kneepad
assembly
side support arm
3. Attach the kneepad assembly to the two side support arms. Face the square holes
on the side support arms inward; t the square shoulder of each carriage bolt
in the square hole, installing each carriage bolt through the kneepad assembly
bracket and side support arm from the inside as shown above. Install the at
washer, lock washer, and acorn nut on the end of each carriage bolt as shown
above. Do not tighten the nuts; some play in this assembly will be needed to as-
semble the entire unit. The nished assembly is shown at right above.
button socket head
cap screw
tubular
cross bar
seat pad and
handle bar
support unit
seat and cross bar
assembly
4. Insert the two tubular cross bars into the holes on the seat pad and handle bar
support units as shown above. Align the small holes on the cross bar undersides
with the holes in the support units. Install the four button socket head cap screws
through the support units into the cross bars. Use the hex key to tighten. The
nished assembly is shown at right above.