Filter
Top Products
ENGLISH
58
SPECIAL SETTINGS
----------------------------------------------------------------------------------------------------------
Tuning analogue television
channels
This setting is only necessary if you cannot re-
ceive any digital channels and you have not car-
ried out an analogue search during initial setup.
The television channels can be set directly or
using the scan.
Switching the television to
analogue reception
Note:
7
Analogue channels can be selected if the
option »Air« or »Cable« has been selected.
1 Open the »Select input source« menu with »
«.
2 Depending on the antenna system, select the
option »Air« or »Cable« with »
V
«, »
Λ
«, »
<
«
or »
>
« as the input source and press»OK«
to confirm.
Note:
7
Additional operations are explained in the
following sections.
Setting all analogue television
channels
Analogue channels are displayed in the channel
list after the digital channels.
Note:
7
Plug the rooftop antenna cable (for analogue
television channels) into the »ANT IN«
socket on the television.
1 Open the menu with »MENU«.
2 Select the line »SOURCE SETUP« with »
V
«
or »
Λ
« and press »OK« to confirm.
– The »SOURCE SETUP« menu appears.
3 Select the line »Source« with »
V
« or »
Λ
«
and press »OK« to confirm.
Select the option »Air« or »Cable« with »
<
«,
»
>
«, »
V
« or »
Λ
« and press »OK« to con-
firm.
4 Select the line »Automatic Channel Search«
with »
V
« or »
Λ
« and press »OK« to con-
firm.
5 Select the line »Country« with »
V
« or »
Λ
«
and press »OK« to confirm. In the country
selection menu, select the country with »
<
«,
»
>
«, »
V
« or »
Λ
« and press »OK« to confirm.
6 Select the line »Scan Typ« with »
V
« or »
Λ
«
and set the option »ATV« with »
<
« or »
>
«.
7 Start the scan with »
« (red).
Note:
7
After starting the scan, a security query will
appear. Press »
« (green) to confirm the
option »Yes«.
– All channel and favourites lists for the ana-
logue channels will be deleted and com-
piled anew.
– The »Results« menu appears, and the scan
for TV channels begins. Depending on the
number of television channels received,
this can easily take a few minutes.
– The search is complete as soon as the »PRO-
GRAM TABLE« appears.
Note:
7
You can abort the search by pressing
»MENU«.
8 Press »MENU« to end the setting.
Source
Cabel
Automativ Channel Search
Analogue Manual Tuning
Signal Information
Digital Manual Tuning
Program Table
CA - Modul
Beenden
Zurück
SOURECE SETUP
20.09.2010
15:46