Filter
Top Products
69
ENGLISH
SPECIAL SETTINGS
----------------------------------------------------------------------------------------------------------
User mode
You can adjust the alignment of the satellite an-
tenna to each individual satellite. These settings
will be saved so that the antenna can later be
easily guided to each saved alignment.
1 Select the line »User mode« with »
V
«
or »
Λ
« and press
»OK«
to confirm.
– The »USER MODE« menu appears.
2 Select the preferred option with »
V
«
or »
Λ
«.
– »Satellite«: »Press
OK
«, select a satellite
with »
<
«, »
>
«, »
V
« or »
Λ
« and press
»OK«
to confirm.
– »Transponder«: »Press
OK
«, select the
transponder from which the signal is being
received with »
<
«, »
>
«, »
V
« or »
Λ
« and
press
»OK«
to confirm.
– »Moving Mode«: Use »
<
« or »
>
« to select
the option »Discrete« or »Continuous«.
– »Discrete«: Moves the antenna in
defined steps to the west and the east.
– »Continuous«: Moves the antenna to the
west or east continuously.
– »Step Size«: Use »
<
« or »
>
« to select the
number of steps with which the antenna
should turn. »Step Size« is only active
when the »Transport Mode« was set to
»Discrete«.
– »Move Motor«: Aligns the antenna with
the selected satellite. Use »
<
« to align it to
»West«, use »
>
« to align it to »East«.
– »Go To Stored Position«: Aligns the antenna
to a saved satellite position. Up to 50 posi-
tions can be saved. »Press
OK
« and then
select the saved position with »
<
« or »
>
«.
Press »
« (green) to confirm – the anten-
na will be aligned with the saved position.
– »Store Stored Position«: The current anten-
na alignment is saved.
3 Press »MENU« to end the setting.
Expert mode
You can restrict the antenna's range or reset
the antenna.
1 Select the line »Installer Mode« with »
V
« or
»
Λ
« and press
»OK«
to confirm.
– The »INSTALLER MODE« menu appears.
2 Select the preferred option with »
V
«
or »
Λ
«.
– »Limit Position«: Defines the range in
which the antenna may move. Use »
<
«
to set the western limit, use »
>
« to set the
eastern limit.
– »Move Motor«: Aligns the antenna with
the selected satellite. Use »
<
« to align the
antenna to »west«, use »
>
« to align the
antenna to »east«.
– »Go To Stored Position«: Press
»OK«
to
save the current antenna alignment.
– »Store Stored Position«: Aligns the antenna
with the reference point of the positioner.
– »Reset DiSEqC 1.2 Limit«: Resets the limit
position of the antenna.