Filter
Top Products
Caution:
INSPECTION, MAINTENANCE, AND CLEANING
1. Caution: Always disconnect the power tool(s) mounted on the Tool Stand from
their electrical/compressed air power sources before performing any inspection,
maintenance, or cleaning on the Tool Stand.
2. Before each use, inspect the general condition of the Tool Stand. Check for
cracks and bends in the product, loose or missing Carriage Bolts (part #7), loose
or improper mounting of a tool, and any other condition that may affect the safe
operation of the Tool Stand. If abnormal noise or vibration occurs, turn off the tool
that is mounted on the Tool Stand immediately and have the problem corrected
before further use. Do not use damaged equipment.
3. Do not use solvents to wipe off the Tool Stand, as damage may result. If
necessary, wipe with a damp cloth. You may use a mild detergent.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THIS MANUAL AS
A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER
THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR
THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN
FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL
REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED
AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES
ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 46075 PAGE 7
When using the Tool Stand to support a power tool, the power tool
must be properly secured to the Tool Stand using appropriate hardware
(not included). Always read and understand all safety warnings
and instructions provided in the instruction manual provided by the
manufacturer of the power tool being mounted to the Tool Stand.
Before mounting the power tool on the Tool Stand, make sure that
the power tool’s manufacturer endorses the use of the power tool
mounted on a Tool Stand.