Hitachi 32PD7800 Flat Panel Television User Manual


 
25
ENGLISH
OPERATING INSTRUCTIONS (continued)
Power Swivel
This feature controls the motorized stand. It allows turning the plasma display left or right using the remote control.
Make sure that the main power switch of the monitor is turned off when removing or connecting the power cord, the connector cables, and
the speaker cables.
CAUTION
1. Press Swivel button.
The controlling icon appears on the screen.
If the connecting cable is not connected, the indication "Not Available" appears.
The swivel display disappears in about 6 seconds without any operation.
Swivel
2. Adjust for preferred angle.
Facing directions are displayed on the screen while the monitor is swiveled.
Adjust by using key while the swivel display is on the screen.
Swiveling angle of the monitor is available within Ȁ30 degrees from the front face.
ATTENTION
Do not add excess power by hands while using the power swivel function. It could cause troubles.
Do not get on and/or hang down the monitor. Do not swing the monitor back and forth and around either. It could cause the failure of the
stand.
Do not put hands or faces close to the monitor while operating the swivel function. It could cause a physical injury. Use special caution in
households where children are present.
Do not put any object, like a vase, near the monitor in swiveling area. It would cause a breakage of the object and /or a failure of the stand.
Place the monitor on the stable location, or the swivel function would not operate correctly. It would cause the malfunction.
In the case of using the monitor wall mounted, be sure to detach the connecting cable between the monitor and the stand.
Caution when connecting the monitor with the stand
* This power swivel function might not be provided depending on a model.
When detach the stand from the
monitor, make sure to detach the
connector cable from the stand
connection terminal on the rear of the
monitor.
Make sure that the direction of the connector for stand connecting cable is correct.
When attach the stand to the monitor
once again, insert the connector
cable into the stand connection
terminal on the rear of the monitor.
Pinch right and left
locks of the connector
and pull out downward.
Insert until it clicks.