Filter
Top Products
36
OPERATING INSTRUCTIONS (continued)
SETUP MENU (Video mode)
Picture
Audio
Timer
Function
Setup
Language
Select
OK Set
Setup
System System 1
Color System
Video Input
RGB1 DVI-STB
RGB2 Component
HDTV
Select Set Return
OK
Setup
Color System
AV1 Auto
AV2 PAL
AV3 SECAM
AV4 PAL
AV5 Auto
Select Return Exit
Setup
Video Input
AV1 Auto
AV2 Auto
Select Return Exit
MENU
Setup
System System 1
Color System
Video Input
RGB1 DVI-STB
RGB2 Component
HDTV
Select Set Return
OK
Selected characters Setup hint
System1 System2
Auto PAL SECAM
System1
System2
NTSC3.58 NTSC4.43
Auto NTSC-M
PAL-N PAL-M
Auto HDTV SDTV/DVD
System
Color System
Video Input
AV1~AV5
AV1, AV2
Do not change the original setting.
(System1 : Europe/Asia, System2 : North America)
DVI-PC DVI-STB
RGB1
This should correspond to the signal mode of the signal from the equip-
ment that is connected to RGB1 DVI terminal.
This should correspond to the color system of the signal from the equip-
ment that is connected to AV1~AV5 video input terminal.
• Normally, set this to Auto. The system of the input signal will be auto-
matically recognized.
• If the input signal contains much noise or has a low level at Auto and
the operation is found erratic, set this to match the input signal.
• When the component signal is received, this would be not available
(grayed out).
This should correspond to the signal mode of the signal from the equip-
ment that is connected to AV1, 2 video input terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and
the operation is found erratic, set this to match the input signal.
RGB Component
RGB2 (1st step)
This should correspond to the signal mode of the signal from the equip-
ment that is connected to RGB2 D-sub terminal.
Auto HDTV SDTV/DVD
RGB2 (2nd step)
This step should be set only when [Component] is selected on the 1st
step.
This should correspond to the signal mode of the signal from the equip-
ment that is connected to RGB2 D-sub terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains much noise or has a low level at Auto and
the operation is found erratic, set this to match the input signal.