Hitachi 42HDT79 Flat Panel Television User Manual


 
68
On-Screen Display
Set The Inputs
Setup
Move SEL Return
Input1 :
****
Input2 :
****
Input3 :
****
Input4 :
****
Auto Link : O
Input5 :
****
Set The Inputs
Set The Screen Saver
Set The AV Net
Set The Menu Options
Set The Closed Captions
Set The Output Terminals
Set The Quick Start Options
Setup
Reset The Software
Move SEL Select
OR
Set The Inputs
Set The Screen Saver
Set The AV Net
Set The Menu Options
Set The Closed Captions
Set The Output Terminals
Set The Quick Start Options
Setup
Reset The Software
Move SEL Select
Setup
Timers
Locks
TV Guide On Screen
Channel Manager
Audio
Video
Move
SEL
Select
Power Swivel
OR
Setup
Set The Inputs
Use this feature to give a name to any of the five video
inputs.
1. Press the CURSOR PAD
̆ or ̄ to highlight the
video inputs.
2. Press the CURSOR PAD
̇ or ̈ to select your
choices.
INPUT 4 Auto Link
Use this function to automatically turn the TV on and
tune to INPUT 4 when it detects a video signal to
INPUT 4.
1. Use the CURSOR PAD
̆, ̄, ̇ or ̈ to
highlight and select the AUTO LINK setting of
your choice.
- Auto
When AUTO is selected, the TV will turn on
and switch to INPUT 4 automatically, when the
INPUT 4 input device is turned on. This is
convenient when you want to watch a movie with your VCR, laserdisc player or DVD player.
- Remote
When REMOTE is selected, the TV will turn on and switch to INPUT 4 automatically when the INPUT 4
input device is turned on and the VCR, laserdisc, or DVD play button on your remote control is pressed.
This is convenient when you want to record a movie with your VCR and watch it later.
- Off
Select OFF to disable this function.
2. Press EXIT to quit menu or select SET THE INPUTS to return to previous menu.
NOTE: 1. Once the TV has been turned on using the AUTO LINK feature, it must be reset before AUTO LINK
is used again. To do this, turn your VCR, laserdisc, or DVD player OFF. This feature is now reset and
will turn on your TV as described above.
2. When using REMOTE mode, any remote control button will substitute for your video input device
play button. However, intended operation is for use with your VCR, laserdisc, or DVD play button.
3. If no remote control button is pressed after the TV is turned on by AUTO LINK, the TV will
automatically turn off after three hours.
Set AV Net (only HDX model)
Use this feature to control your external Audio/Video
equipment using your HITACHI Plasma TV Remote
Control. The IR Blaster cable must be properly
connected for the AV NET feature to work.
1. Press the MENU button.
2. Use the CURSOR PAD
̄ or CHANNEL WHEEL to
highlight SETUP.
3. Press the SELECT button to select.
4. Use the CURSOR PAD ̄ or CHANNEL WHEEL to
highlight SET AV NET feature.
5. Press the SELECT button to select.
Set AV NET
Note: The inputs labeled Gray out (Skip) or Hide
(Skip) are disabled in the INPUTS selection.