Filter
Top Products
REAR PANEL CONNECTIONS - 12 -
To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the
Y-CbCr jacks.
When using the Y-CbCr jacks, Input 2 will be viewed as a blank PIP sub-picture. (See page 24.)
REAR PANEL CONNECTIONS
Rear Panel Connections Illustration
Typical full feature setup. Follow connections that pertain to your personal entertainment system.
TIPS ON REAR PANEL CONNECTIONS
S-Video connections are provided for high performance laserdisc players, VCRs etc. that have this feature. Use
this connection in place of the standard video connection if your device has this feature.
If your device has only one audio output (mono sound), connect it to the left audio jack on the television.
Refer to the operating guide of your other electronic equipment for additional information on connecting your
hook-up cables.
A single VCR can be used for VCR #1 and VCR #2, but note that a VCR cannot record its own video or line
output (INPUT: 1 in the example on page 12.) Refer to your VCR operating guide for more information on line
input-output connections.
You may use Video, S-VIDEO, or COMPONENT: Y-CbCr inputs to connect to Input 2, but note that only one of
these may be used at a time.
Connect only 1 component to each input jack.
COMPONENT: Y-CbCR connections are provided for high performance components, such as DVD players. Use
these connections in place of the standard video connection if your device has this feature.
When using the Y-CbCr input jacks, connect your components audio output to the TV's Input 2 Left and Right
Audio input jacks.
Your component outputs may be labeled Y, B-Y, and R-Y. In this case, connect the components B-Y output to the
TV's Cb input and the components R-Y output to the TV's Cr input.
It may be necessary to adjust TINT or turn AUTO COLOR-ON to obtain optimum picture quality when using the Y-
CbCr inputs. (See page 49 and 50.)
To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using the Y-CbCr jacks.
When using the Y-CbCr jacks, Input 2 will be viewed as a blank PIP sub-picture. (See page 24.)
EXTERNAL CONNECTIONS
CONNECTING EXTERNAL AUDIO AMPLIFIER
To control the audio level of an external audio amplifier with the remote control, connect the system as shown
below.