Filter
Top Products
USING THE REMOTE TO CONTROL AUDIO EQUIPMENT FUNCTIONS - 22 -
remote control. After replacing the batteries repeat the entire programming procedure as stated above.
4. If your cable/satellite box does not have a power function, the remote will issue the CHANNEL UP function.
5. The LST-CH button will act as your cable/satellite box ENTER button if required.
6. The SLEEP button will act as your cable box '100' button if required.
7. The INPUT button will act as the TV/DSS button when in DSS mode.
Remote Control Illustration.
1 PRECODED CABLE BOX buttons
These buttons transmit the chosen precoded cable codes.
2 PRECODED SATELLITE BOX buttons
These buttons transmit the chosen precoded satellite codes.
3 EXCLUSIVE TV buttons
These buttons are for operating the TV.
USING THE REMOTE TO CONTROL AUDIO EQUIPMENT FUNCTIONS
Operating the precoded function for your audio equipment.
This remote is designed to operate certain types of audio equipment. You must first program the remote to match
the remote system of your audio equipment. (Refer to page 30.)
1. Set the MULTI-PAGE select switch to AUDIO.
2. Turn ON the audio component you wish to control with your remote control (AMP, CD or TAPE).
3. Aim the remote control at the front of your audio equipment.
4. Hold down the button on the remote which corresponds with the component you wish to control (AMP,
CD, or TAPE), enter the two digit preset code that matches your audio component as shown on page
30. The remote will turn off your audio component when the correct two digit preset code is entered.
When this occurs, the remote control is programmed for your audio component. If the audio component
does not turn off after five seconds, try a different two digit preset code.
5. The remote will now control your audio component.
6. Repeat steps 2-5 until all audio equipment preset codes are programmed into the remote.
NOTES:
1. If your audio equipment cannot be operated after performing the above procedures, your audio component
code has not been precoded into the remote.
2. In the unlikely event that your audio component cannot be operated after performing the above procedures,
please consult your audio components operating guide.
3. The remote control will remember the codes you have programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the entire programming procedure as stated above.
4. If your audio component does not have a power function, the remote will issue another obvious function that
the audio component will respond to, such as CD open/close.
5. The default for AUDIO mode is AMP.
6. If you wish to control your Receiver or miscellaneous audio equipment, you must follow the remote
programming procedure shown above. You may use only the AMP button to program these codes, but note
that this button may not be used for more than one component.
7. The LST-CH button will act as your audio component's ENTER button if required.
8. The SLEEP button will act as your audio components '100' button if required.
Remote Control Illustration.
1 PRECODED AMP, CD, or TAPE buttons
These buttons transmit the chosen precoded audio component codes.
2 EXCLUSIVE TV buttons
These buttons are for operating the TV.
AUDIO, CABLE/SATELLITE, AND VCR CODES
AMPLIFIER
BRAND
CODE AMPLIFIER
BRAND
CODE AMPLIFIER
BRAND
CODE