Hitachi 50UX58K Projection Television User Manual


 
HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV- 17 -
HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV
Genius Remote Control Illustration.
1 POWER button
Press this button to turn the TV set on or off when the remote is in TV mode. (See page 19 for
instructions on how to set the remote control to TV mode.) If a Special Event Reminder is set, it will be
displayed when the TV is first turned on. (See page 56.)
2 TV button
Press this button to allow the remote to control your TV.
3 CABLE button
Press this button to allow the remote to control your cable box. (See page 28.)
4 DSS button
Press this button to allow the remote to control your satellite box. (See page 28.)
5 PICTURE-IN-PICTURE buttons
See separate section on page 24 for a description.
6 PIP CH button
Use the PIP CH button to select between main picture and sub-picture tuning. A blue highlight of the
channel number will indicate which channel is being controlled.
7 HELP button
Press this button when a menu is displayed to view HELP text, which give a description of the displayed
menu. The HELP text will be displayed every time a MENU is displayed, until this button is pressed
again or the AUTO HELP FUNCTION is set to OFF. (See page 58.)
Help Button Illustration
8 LAST CHANNEL (LST-CH) button
Use this button to select between the last two channels viewed. (Good for watching two sporting events,
etc.)
Last Channel Illustration
9 VOLUME, MUTE buttons
Press the VOLUME up (
) or down ( ) button until you obtain the desired sound level.
To reduce the sound to one half of normal volume (SOFT MUTE) to answer the telephone, etc., press
the MUTE button again to turn the sound off completely (MUTE). To restore the sound, press the
MUTE button one more time, or press the VOLUME up (
) button.
Volume, Mute Illustration
10 CHANNEL SELECTOR buttons
CHANNEL SELECTOR buttons are used to set Family Favorites, Channel Memory, etc..
Enter two or three numbers to select channels. Enter "0" first for channels 1 to 9 . For channels 100 and
above, press the "1" button, wait until another dash appears next to the channel display on your TV,
then enter the remaining two numbers using the number buttons.
Channel selection may also be performed by pressing CH up (
) or down ( ).
NOTE: The TV may not receive some channels if you are not in the correct SIGNAL SOURCE mode. (See
page 35.)
11 EXIT button
When in MENU mode, this button will exit all On Screen Displays.
12 RECALL button
Press this button when no menu is displayed when you want to check the channel being received, the
picture source, if the channel has stereo (ST) or second audio program (SAP), the time, CHANNEL
ID, and if the SLEEP timer has been set.