Hitachi 51F59A Projection Television User Manual


 
Setup
On-Screen Display
58
INPUT 3 Auto Link
Use this function to automatically turn the TV on and
tune to INPUT 3 when it detects a video signal to
INPUT 3.
1. Use the CURSOR buttons
̇ or ̈ to highlight the
AUTO LINK setting of your choice.
2. When AUTO is selected, the TV will turn on and
tune to INPUT 3 automatically, when the INPUT 3
input device is turned on. This is convenient when
you want to watch a movie with your VCR,
laserdisc player or DVD player.
3. When REMOTE is selected, the TV will turn on and switch to INPUT 3 automatically when the INPUT 3 input
device is turned on and the VCR, laserdisc, or DVD play button on your remote control is pressed. This is
convenient when you want to record a movie with your VCR and watch it later.
4. Select OFF to disable this function.
5. Press EXIT to quit menu or select AUTO LINK to return to previous menu.
NOTE: 1. Once the TV has been turned on using the AUTO LINK feature, it must be reset before AUTO LINK
is used again. To do this, turn your VCR, laserdisc or DVD player OFF. This feature is now reset and
will turn on your TV as described above.
2. When using REMOTE mode, any remote control button will substitute for your video input device
play button. However, intended operation is for use with your VCR, laserdisc, or DVD play button.
3. If no remote control button is pressed after the TV is turned on by AUTO LINK, the TV will
automatically turn off after three hours.
Set Virtual HD
Set The Inputs
Setup
Input5
Input1
Input2
Input3
Input4
Move
SEL Return
AutoLink
Auto Remote Off
RenameList
AVR DVD PVR STB2
CAM DVD2 PVR2 VCR
CBL DVD3 SAT VCR2
CBL2 LD STB VCR3
Reset
OR
1080i
OR
Set Virtual HD
Next/Prev. SEL Return Select
Use this feature to select between 1080i and 540p
scan mode.
NOTE: VIRTUAL HD is not available (grayed out) in Digital Channels, 1080i input, HDMI and components.
Off
OR
Set Black Side Panel
Next/Prev. SEL Return On/o
The BLACK SIDE PANEL function turns the gray side
bars on/off when watching 4:3 signals in Standard mode.
Set Black Side Panel
NOTE: To maximize operating life of the TVs picture tubes when watching 4:3 signal, Black Side Panel is
cancelled at Power OFF. It is recommended to watch 4:3 signal with gray side bar.
The top/bottom gray bar will appear in SPLIT MODE PIP
and SPLIT FREEZE. The TV set will always return to "Set
Black Side Panel -OFF" setting every time the TV is
powered "OFF".
When content from film is sent to your home it requires processing that can cause picture noise or distortion.
Virtual HD technology reduces this noise to a minimum, recreating the smooth curves and high fidelity image of
the original film source.