Hitachi 51F59A Projection Television User Manual


 
57” Disassembly/Assembly Instructions
Useful Information
STEP 4
STEP 5
Remove the joint connector bolts from each side
of the back cover using the allen wrench that is
provided inside of the instruction bag, see (a)
and (b). In case that the screw is different type
STEP 6
Remove from the
back side of the TV
set only the top 4
screws of the lower
rear cover, see (b),
as shown by the
arrows on the rear
cabinet label, see (a). Do not remove the rear cover board. Remove the (4) four side screws that hold the back
cover to the cabinet, see (c) as shown on the label (a). Total of 8 screws will be removed.
STEP 7
CAUTION: When the TV is separated, the top
portion weights 45 lbs. This task should be done by
two persons when separating this TV.
This assembly contains fragile parts, such as glass
and the viewing screen. Avoid any type of impact
that could cause breakage of these components.
Remove top portion
by grabbing the
bottom corner of
frame and the back
cover, see (a)(b). Lift
upwards, see (c)(d),
gently place the top
portion on the the
floor, see (e).
(a) (b)
(a)
(a) (b)
(c)
(d)
(e)
62
Locate the SENSOR PWB attaced to the cabinet
(a). Losen the sensor wires from the plastic holders
in order to remove the 3 wires that comes from
the screen, see (b). Disconnect the 3 connector wires
as it shows on picture (c) & (d).
(a)
(b)
(b)
(c)
(c)
(d)
use the proper screwdriver to remove the screws.