Hitachi 51F710S Projection Television User Manual


 
74
65” DISASSEMBLY/ASSEMBLY INSTRUCTIONS
IMPORTANT POINTS:
CAUTION: DISCONNECT UNIT FROM POWER SOURCE BEFORE DISASSEMBLY / ASSEMBLY
1 - SEPARATION PROCEDURE (Note: read all instructions and understand how to properly and
safely disassemble and assemble unit)
(a) Do not attempt to perform this work by yourself.
(b) Request an installation specialist to install this unit.
(c) HITACHI assumes no responsibility or liability for injury/damage as a result of con-
sumer installation and handling. Be advised that improper consumer installation/han-
dling is not covered by manufacturer’s warranty.
(d) This Projection Television weighs 309 pounds and has many sensitive components.
STEP 1
Before disassembling this projection TV set, you must first remove the speaker grille by grabbing the sides and pulling left and right side
see (a)(b). Remove the front decoration panels by unscrewing the 2 screws from each panel, see (c), then remove from the original posi-
tion, see (d)(e).
STEP 3
Remo
v
e the sensor bo
x by unscrewing the 2 screws located on both sides of the sensor box, see (a). Rotate the sensor box and there are 4 low
v
oltage connectors located on the sensor board, see (b).
Disconnect wires (PDSE), see (c) and (d).
(Make sure to push the center lock on the con-
nector at the unplug time
.)
(a) (b)
(c)
(d)
(e)
STEP 2
Remove the 8 screws that hold the screen frame to the cabinet on the front side. DO NOT remove the right and left edge screen frame screws (c).
(a)
(b)
(a)
(b)
(c)