Filter
Top Products
CONNECTING EXTERNAL VIDEO SOURCES
15
The exact arrangement you use to connect the VCR, camcorder, laserdisc player or DVD player to your TV set is dependent on the
model and features of each component. Check the owner’s manual of each component for the location of video and audio inputs and
outputs.
The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate your
particular assortment of components and features. For best performance, video and audio cables should be made from coaxial
shielded wire.
Before Operating External Video Source
The input mode is changed every time the INPUT button is pressed as shown below. Connect an external source to the INPUT
terminal, then press the INPUT button as necessary to view the input source. (See page 21)
Ant A 12
Video:1
INPUT MODE SELECTION ORDER
(ANTENNA)
(INPUT)
INPUT
CONNECTING A MONAURAL AUDIO TO INPUT1~INPUT4
1. Connect the cable from the VIDEO OUT of the monoaural source to the INPUT (VIDEO) jack, as shown on the TV set below.
2. Connect the cable from the AUDIO OUT of the monaural source to the INPUT (MONO)/L(AUDIO) jack.
3. Press the INPUT button to view the program from the monaural source. The VIDEO mode disappears automatically after
approximately eight seconds.
4. Press the INPUT button to return to the previous channel.
NOTE: When the TV is set to VIDEO and a video signal is not received from the VIDEO INPUT JACK on the back panel of the
TV (i.e., VCR/laserdisc player, etc. is not connected or the video device is OFF), the set will appear to be OFF.
P
B
P
R
AUDIO TO HI-FI
MONITOR
OUT
INPUT 1
AUDIO
(MONO)
L
R
AUDIO
L
R
S-VIDEOS-VIDEO
VIDEO
VIDEO
AUDIO
L
R
(MONO)
S-VIDEO
VIDEO
Y/VIDEO
R
L
AUDIO
L
R
INPUT 2 INPUT 4
(MONO)
ANT A
TO
CONVERTER
ANT B
Hitachi Model or
Similar Model
VIDEO OUTAUDIO OUT
VCR
Back of
VCR