21
HOW TO USE THE GENIUS REMOTE TO CONTROL YOUR TV
ቪ SLEEP button
Press this button to display the sleep timer in the lower left corner of the screen. Every subsequent press of this button will add 15
minutes to this timer, up to a maximum of three hours. Once set, use STATUS when you want to view time remaining. If the SLEEP
button is pressed while the timer is set, it will reset to the original condition.
ቫ LAST CHANNEL (LAST CH) button
Use this button to select between the last two channels viewed. (Good for watching two sporting events, etc.)
ቭ INPUT button
Press this button to select from the four input sources and the two antenna sources.
ቩ CHANNEL selector buttons
CHANNEL selector buttons are used to set FAMILY FAVORITES, CHANNEL MEMORY, etc.
Enter one, two, or three numbers to select channels. Enter 0 first for channels 1 to 9, or simply press the single digit channel you
wish to tune then wait a few seconds for the TV to tune. For channels 100 and above, press the 1 button, wait until two dashes
appear next to the channel display on your TV, then enter the remaining two numbers using the number buttons.
Channel selection may also be performed by pressing CH up (̆) or down (̄).
NOTE: The TV may not receive some channels if you are not in the correct SIGNAL SOURCE mode. (see page 35)
Ant A 10
Ant A 39
LAST CH
ቮ HELP button
Press this button when a menu is displayed to view HELP text, which gives a description of the displayed menu. The HELP text
will be displayed every time a MENU is displayed, until this button is pressed again.
ቯ PIX button
Press this button repeatedly to direct access THEATER MODE between Sport, News, Movie, and Music.
ተ MENU button
The MENU button will start the On-Screen Display.
ቱ EXIT button
When in MENU mode, this button will exit all On-Screen Displays.
ቨ AV1, AV2, AV3, or CD, TAPE, AMP buttons
When pressed, each of these buttons will blink to indicate the remote is in Audio/Video mode. (see page 30)
NOTE: Your remote control SOURCE WIZARD buttons are either labeled as AV1, AV2 and AV3, or CD, TAPE, and AMP.
If your remote control SOURCE WIZARD buttons are labeled as AV1, AV2, and AV3, please program your Audio/Video
components as follow for best performance. Use AV1 to program your CD brand. Use AV2 to program your TAPE
brand, and use AV3 to program your AMPLIFIER/RECEIVER brand.
AV1-Use for CD brand
AV2-Use for TAPE brand
AV3-Use for AMPLIFIER/RECEIVER brand.
AV2
AV1
AV3
DVD
SOURCE WIZARD
Ant A 28
TAKA
Video:1
VID1
Stereo
ST/SA
Video:2
VID2
Video:4
VID4
Ant B 32
TAJK
Video:3
VID3
INPUT
INPUT
INPUT
INPUT
INPUT
INPUT