Filter
Top Products
USING THE REMOTE TO CONTROL VCR FUNCTIONS - 17 -
To move the sub-picture to another corner, press the "SHIFT" button. The sub-picture moves one step counter-
clockwise every time the "SHIFT" button is pressed.
FOLIOHG2
<IMG SRC="ObjFE6.PCX">
4 FREEZE (FRZ) button
If you wish to freeze the sub-picture, press the "FRZ" button. This is convenient when trying to write down the
address for a mail order company, recording statistics for a sporting event, etc. To return the picture to motion,
press the button again.
5 FREEZE (FRZ) button without a sub-picture (QUICK FREEZE)
Press this button without a sub-picture to freeze the picture you are currently viewing. Press this button again to
return to normal viewing. The SWAP button will not work with this QUICK FREEZE function.
FOLIOHG2
<IMG SRC="ObjFE7.PCX">
CAUTION: A pattern burn may develop if the sub-picture is left in the same corner permanently. If the
PIP feature is used frequently, occasionally shift the sub-picture to a different corner.
NOTE: Only sound from the main picture can be heard..
USING THE REMOTE TO CONTROL VCR FUNCTIONS
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCR's. You must first program the remote to match the
remote system of your VCR. (Refer to page 22.)
Click for image of Remote CLU-415UI Illustration
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. Hold down the VCR button on the remote, enter the 2 digit preset code that matches your VCR as shown on
page 22. The remote will turn off your VCR when the correct 2 digit preset code is entered. When this occurs, the
remote control is programmed for your VCR. If the VCR does not turn off after 5 seconds, try a different 2 digit
preset code.
4. The remote will now control your VCR.
NOTES:
1. If your VCR cannot be operated after performing the above procedures, this means that your VCR's code has
not been precoded into the remote.