SET UP TV GUIDE Plus+
STEP 6
1. Turn your cable box ON and tune it to channel 02.
2. Use the CURSOR buttons to select your cable box brand from the list,
then press SELECT. (It will take a few seconds for TV GUIDE Plus+ to
check the cable box code.)
TV GUIDE Plus+ Setup
Tune your cable box to channel 02. Select
your cable box brand from the list below.
I
Hitachi
I
press “Pldmv” to change brand. The”. pr**s Select.
NOTE: When using a cable box with TV Guide Plus+, set your remote to TV mode. This allows your IR Blaster
connector to control your cable box, enabling you to see channel call letters when changing channels or
pressing RECALL.
Basic connection for TV GUIDE Plus+ setup with cable box and without VCR.
Coaxial Cable
ff
Cable TV Box
To IRlGLlNK
REARSPEAKER
v
8 n ONLY
ANT A
I 7 COMPONENT 7
VIDEO
AUDIO
t I I
,NPUT, ,NP”T 2 MO~t$OR WlRELES AUDIO
OUT TO HI-FI
STEP 7
1. If your cable box switches to Channel 09, use the CURSOR buttons to
select YES. Then press SELECT.
2. If your cable box does not switch to Channel 09, use the CURSOR
buttons to select NO. Then press SELECT. TV GUIDE Plus+ will try
another version of cable box code (ie. 16-02.)
TV GUIDE Plus+ Setup
Did Cable Hitachi code 16-01 switch your
cable box to 09?
IJ Yes
I
NO
Press “p/down to change brand. The”. press Select.
(If TV GUIDE Plus+ does not recognize your cable box after several tries, a screen stating, “Cable box test failed. Please
consult your manual and try again” will appear. You should check the CATV brand again and repeat these steps. Also,
check that the If? Mouse is in front of the cable box’s IR receiver window.)
18