Filter
Top Products
Unless you apply the head to your skin while touching the back plate, the device
will not vibrate. (skin sensing function)
If the head is not vibrating, the device is not working.
If you leave the device as it is for about 5 minutes without vibration, the device will
automatically switch "Off." (Automatic shutoff function)
Make sure to hold the body with your hand touching the back plate.
4 Hold the device with your hand touching the back plate of the body.
(Fig. 7)
5 Apply and move the head slowly.
(Fig. 8)
When using a sheet mask, slide the head over the sheet mask.
The mode indicator lamp will switch and turn on, and the device will start to vibrate.
The time for use is within 5 minutes.
CAUTION
Do not apply the device on the same area of skin for more than 10 seconds.
If you feel your skin tingling by micro current while using the device, press the level
switch button and switch to "Low."
7 Wipe off the moisturizing product on the head and the body of the device with a tissue.
6 After 5 minutes have elapsed, the device will automatically shut off.
(Auto shutoff function)
The finish sound (beep beep) will inform you.
How to use with AC
1 Connect the power adaptor to the main body and outlet.
2 Make sure to pull out the power adaptor from the outlet and the body.
Follow "How to use" for use.
While the device is being used, the battery indicator lamp will be off.
It is recommended that when using the device for the first time or if you feel some
discomfort, use the device in "LOW."
Do not keep the head in the same area of the skin, but move it
around. (Cause of problems with your skin or poor health)
Avoid using in a place where water is splashed such as a bathroom
or in a place with high moisture.
(Cause of electric shocks and short circuits)
About skin sensing function
This device is a product which operates through the human body.
Applying the skin to the back plate and the head will make an electrical circuit start to
operate. Unless you touch the back plate and apply the head to the skin, it will not start
to operate.
About memory function
This device is equipped with a memory function to store memory of the electrical
potential "strength" levels of “HIGH,” “MEDIUM,” or “LOW”.
In each usage mode (Step 1 to 3), the device stores memory of the "strength" level just
before the automatic shutoff or the power switch is turned "off."
If the level switch button is pressed while the device is being used, the electric potential
"strength" can be switched.
Apply the head gently to the face and slowly move the device by sliding it from
the center of the face to the outer side.