Filter
Top Products
Wipe off the toner/moisturizing product on the head and the body with a tissue.
When dirt is difficult to remove, wipe it off with a cloth after saturating it with water and
wring it thoroughly.
Care for main body
Do not use alcohol, benzine, or thinner.
(Cause of deformation or discoloration)
CAUTION
How to preserve
Store the device on the included stand in a place free from excessive humidity or dirt.
The stand can store the rings in it as well as put the body on it.
(Fig. 12)
Do not leave in an area subject to direct sunlight (inside of a vehicle in
summer, etc.) or near heaters. (Cause of deformation or discoloration)
CAUTION
Disposal of the product
This product includes recyclable parts.
For disposal of the parts, observe your local laws and regulations etc.
Specifications
Do not disassemble except when disposing of the product.
Power adaptor
(KH-182B)
Main body
Power
supply
100 - 240V AC, common to 50-60Hz
Batteries [Nickel-hydrogen battery (1.2V DC, 500mAh )]
5 hours as standard
Charging time
Rings (two), stand
Accessories
Around 15 minutes at the maximum
(basic mode:approximate 10 minutes)
Rated time
How to remove the nickel-hydrogen batteries
1. Keep pressing the power switch continuously while it is
"
ON
"
for about 10 seconds or
more to make the device vibrate and leave it until the vibration stops.
2. Remove the two screws on the reverse side of the main body. (Fig. 13)
Screws
3. Insert a flat-blade screwdriver or the like in the gap between the main body cases (front)
and (rear), and remove the main body case (rear). (Fig. 14)
Main body case (rear)Flat-blade screwdriver
4. Cut the lead wires connected to the terminals of the nickel-hydrogen batteries near the
terminals, and take out the batteries from the battery holder. (Fig. 15)
Main body case (front) Lead wires Nickel-hydrogen batteries Battery holder
Do not allow the (+) and (-) terminals of the removed nickel-hydrogen
batteries to make contact. (Cause of a short circuit or burns)
Do not clean the main body with water. Or do not dip in water,
and do not pour water. (Cause of failure)
Make sure to turn OFF the switch. (Improperly turning on the switch
may give a tingling sensation or result in malfunction or short-circuit.)
Do not leave in a water splashing area or an area with significant
humidity, such as a bath. (Cause of short-circuits or failure)