Filter
Top Products
4
Accessories
First time use
Check to make sure you have the following accessories before disposing of the packing material.
Power Cord
Remote Control
1.5V batteries
Table Top Stand
(50" included)
For U.S. models:
For optional accessories, please access our web site at:
www.hitachi.us/tv
Table Top Stand
(42” included)
Two “AA” size,
Note: Please visit our
website for optional
accessories.
CAUTION: 1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not
provide adequate ventilation for the electronics or proper support for the front glass
panel. This plasma television product is designed for a maximum tilting angle of 45
degrees from vertical.
2. This stand for use only with Hitachi P42T501, P42T501A, P50T501 and P50T501A.
Use with other apparatus is capable of resulting in instability causing possible injury.
³ Remote Control Unit CLU-4371A
(Part No. HL02401).
· Two "AA" size, 1.5V batteries.
» Table Top Stand (UX27662 42" model)
¿ Power Cord (P# EV01841).
³
»
·¿
1.
Open the battery cover of the remote control by pushing down and sliding the back cover off.
2.
Insert two new “AA” size batteries for the remote contr
ol. When r
eplacing old batteries, push them towards the
springs and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery
compartment.
4.
Insert the bottom of the battery
, the (-) side, into the battery
compartment first, push towards the springs and insert the
top of the battery
, the (+) side, into place. Do not for
ce the
battery into the battery compartment.
5. Replace the cover.
Bottom View (Remote Control)
Lift up on tab to r
emove back cover.
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
CAUTION: Do not insert batteries with ‘+’ and ‘-’ polarities reversed as this may cause the batteries
to swell or rupture resulting in leakage.
(UX27282 50" model).
»
3. The wall mount unit for the 50" and 42" models is WM07S and for the
55" models is WM07L. Please see page 7 & 8 for important information related
to the wall mount. Wall Mount unit is an optional accessory (Not Included).
Wire Clamp
(50" models only)
´
´ Wire Clamp (50" models only)