Filter
Top Products
i
cable box. (The VCR channel will not change, but the cable box will change
channels.) Depending on the manufacturer of your cable box, certain models will
allow you to enter the channel directly by using the numbers on the remote.
Gable box did not tune to channel 9: Press number 2 on the remote and enter
a different code from the chart.
If these codes do not work:
Try repositioning the cable box on top of the VCR and reentering the
codes.
Try entering all code numbers (00 - 61). Press CLEAR on remote to
change incorrect entries.
If none of the codes work, press GUIDE to quit. The VCR will not control
your cable box. However, the output channel of the cable box has been set.
Turn on the cable box and leave it tuned to the channel you want to record
some time before the recording is to begin.
Using the VCR Plus+ System to Record a Program
Now that your channels are set up, you can take advantage of this quick and
easy method of delayed recording. You will use the on-screen Easy Guide
System, following the basic procedure for delayed recording outlined on page 41.
See the section on Recording a Program for recording tips and programming
priorities.
You set up the delayed recording using the on-screen Easy Guide System.
1. Press the PROGRAM to bring up this screen:
2. Use the number buttons to enter the PlusCode of the program you want to
record. This code can be up to eight digits. If you enter a wrong digit, press
CLEAR and enter the correct one.
42