Filter
Top Products
i
3. If you accidentally enter a nonexistent PlusCode, the VCR gives you an error
message that disappears from the screen in about 10 seconds.
4. If you have entered the correct PlusCode, press VCR PLUS+ to store the
PlusCode in the VCR's memory. This brings up another screen:
//
5. Press number buttons 1, 2, or 3 to select ONE TIME, DAILY, or WEEKLY
RECORDING.
Important: Programming does not take effect unless you select one of these
options.
6. When the next screen comes up, choose between standard or extended tape
speed by pressing the 5 button. This is also a good time to check the channel
number - it should be the one on which you usually watch the program at home.
(If not, you need to check your VCR Plus+ channel setup.)
7. Review the screen to be sure everything is set as you want, then press
PROGRAM to complete your programming or continue with additional programs.
When you have set up all the timed recordings you want:
Don't forget to load a videocassette (with the safety tab still attached) to record
on.
If using a cable box the VCR can control, turn on the cable box before the time
the recording is to begin.
If using a cable box the VCR cannot control, turn on the cable box and tune it
to the channel you want to record before the time the recording is to begin.
Important: Your timed recording settings take effect when you turn off the power
on the VCR.
43