Filter
Top Products
• Mouse :
• Key lock :
• Factory Reset :
• Cam No. Offset :
• Master/Slave :
• Network Type :
• Baud Rate :
• Unit Address :
• Exit :
If you plan to use a mouse to control you multiplexer, set
this to On.
When On, pressing any key or clicking the mouse will
open a screen asking for a password.
Returns all settings to the factory default.
A confirmation screen will ask you if you really want to reset
everything.
When set to On, the multiplexer will adjust the
camera numbers based on the Unit Address. Unit 001 will have
Cameras 01 to 16, Unit 002 will have Cameras 17 to 32, etc. When
set to Off, the cameras will be numbered 01 to 16.
The ranges which can be changed are Min=minimum, -009~009 and
Max=maximum.
When installed as part of a network, this will
determine if the unit is a master or slave unit.
The can be set to RS-232, RS-422 or
RS-485 when connected to a network.
When connected to a network, the baud rate can be set
to 1200, 2400, 4800, 9600 or 19200.
Networked multiplexers can be assigned addresses
from 001 to 255.
Saves your changes and returns to the Main Menu.
Mouse setup : If the mouse cannot be worked properly, the user can
change the values as follows.
•
• Protocol :
multiplexer
A is multiplexer protocol.
B1 is dome camera control protocol.
49
ENGLISH