Filter
Top Products
**
To initialise satellite position saved at the Motor Antenna, set DiSEqC Command Mode to Installer, set Motor Control to Reset, then
press the OK button. You will see a warning message. To continue the procedure, press the OK button.
To set the motor position for each satellite manually, select your desired Satellite Name, set DiSEqC Command Mode to Installer, and
then set Movement to one option among East, Stop, or West. The motor starts moving. The level of signal strength and quality bar at
the bottom of the screen will indicate the best position of the dish. Set Motor Control to Store when you find the best position, then
press the OK button to save the position.
To move the motor to the pre-set position of the satellite, select your desired Satellite Name, set DiSEqC Command Mode to User, set
Motor Control to Goto, and set Movement to your desired value. The movement is used to fine-tune the position of the motor. Press the
OK button. The motor will move to the position of the selected satellite.
**
5. Motor Limit Setting
To enter this menu, press the RED button in Satellite Setting menu. You can set the maximum for both East and West to prevent
damage to the antenna.
**
• Limit Setting: When Limit setting is set to Enabled, the motor does not
move more than the amount of the limit. When Limit setting is set to
Disabled, the setting is released.
• Movement: You can select one among East, Stop, or West.
• Store East Limit: You can save the East Limit.
• Store West Limit: You can save the West Limit.
GB 20