Filter
Top Products
12
TROUBLESHOOTING GUIDE .............................................................................
PROBLEM CAUSES SOLUTIONS
Transmitter is blank. Transmitter is Off.
Battery is dead.
Press any button for 1 second.
Replace battery.
Can’t access all the desired stations
on the transmitter.
Maximum station number is
set wrong.
See “Setting the Maximum Station stations Number”
Receiver doesn’t beep two times
after plugging it into the SmartPort
®
.
SmartPort is not connected properly.
Controller has no power.
Recheck the SmartPort installation.
Check controller power.
Receiver beeps twice after plugging
it in, but won’t respond to the
transmitter.
Receiver and Transmitter addresses
don’t match.
Relearn address at Receiver.
Transmitter display stays on. Transmitter will turn off
automatically.
Wait approximately 2 minutes without pressing any
buttons. Transmitter will “fall asleep.”