4
To utilize the ICR remote control system, your controller
must be equipped with a SmartPort wiring harness. This
wiring harness provides the communication port where the
ICR receiver is attached. The SmartPort can be connected to
Hunter SRC, Pro-C and ICC controllers. A SmartPort wiring
harness is provided with your ICR remote system. The
typical SmartPort location is approximately 12" below the
controller. The recommended installation procedure for this
location would be as follows:
SmartPort
®
WIRING HARNESS .......................................................................
INSTALLING THE SmartPort
WIRING HARNESS ........................................
1. Install a ½" female threaded “Tee” in the field wiring
conduit approximately 12" below the controller.
2. Feed the red, white, and blue wires of the SmartPort
through the base of the “Tee” and into the controller
wiring compartment as shown in the following figures.
NOTE: The harness may be installed outdoors
by bringing the conduit through an exterior
wall, then installing the appropriate fitting.
NOTE: For installations where the receiver
will be installed permanently on an outside
wall, make certain that the SmartPort is the
version with an o-ring seal.
1
/2" Thread
To Controller
Pre-assembled Assembled