Filter
Top Products
54
5
Hold
Hold
Setting the HOLD switch to the HOLD position.
If you set the recorder to HOLD status by sliding
the HOLD switch in the direction of the arrow, the
current conditions will be preserved, and all buttons
and switches except the HOLD switch will be
disabled. This feature is useful when the recorder
has to be carried in a bag or pocket.
Remember to reset the HOLD switch when using
the recorder.
Running state when HOLD is set
2
On
On
Off
On
On
Off
1
STOPS
Running
3
Not
connected
Off
On
Not
connected
Off
On
4
The display goes out after “HOLD”
blinks for 2 seconds.*
1
The display goes out after “HOLD”
blinks for 2 seconds.*
1
Normal operation
If HOLD is applied during playback
(recording), operation is disabled with the
playback (recording) state unchanged.*
2
If HOLD is applied during playback
(recording), operation is disabled with the
playback (recording) state unchanged.*
2
Normal operation
5
Normal operation. If the recorder
stops after button operation, the
display goes out 20 seconds later.
Button operation on the remote controller
is invalid.
Normal operation. If the recorder
stops after button operation, the
display goes out 20 seconds later.
Button operation on the remote controller
is invalid. However, the REC lamp is lit
while the recorder is recording.
*1: Pressing any button makes clock display blink for 2 seconds but the recorder does not start.
*2: The recorder stops when playback completes or recording terminates due to no memory space.
Note
The alarm will sound at the scheduled time even if the recorder is set to hold. The recorder begins to play the
file associated with the alarm when you press any button.
1: State of the recorder, 2: HOLD of the recorder, 3: HOLD of the remote controller, 4: Button
operation on the recorder, 5: Button operation on remote controller