Filter
Top Products
14
NS-55E560A11 Insignia 55" LED-LCD TV, 1080p
www.insigniaproducts.com
5 Press or to highlight Antenna or Cable,
then press ENTER. Your TV automatically starts
scanning for channels available in your viewing
area.
Understanding the basics
Turning your TV on or off
To turn your TV on or off:
1 Make sure that the power cord is connected to a
power outlet.
2 Press POWER to turn on your TV. The power
indicator LED blinks red, then turns off.
3 Press POWER again to turn off your TV. Your TV
enters Standby mode and the power indicator
LED turns red.
Selecting the video input source
To select the video input source:
1 Turn on your TV, then press INPUT. The Source
List opens.
2 Press or to highlight a video input source,
then press ENTER.
Selecting a channel
To select a channel:
• Press CH + or CH – to go to the next or previous
channel on the memorized channel list.
• Press the number buttons to enter the channel
number you want, then wait for the channel to
change or press ENTER to immediately change
the channel.
• To select a digital sub-channel, press the number
buttons to select the main digital channel, press
(dot), then press the number button for the
sub-channel. Wait for the channel to change, or
press ENTER to immediately change the channel.
For example, to tune to channel 5.1, press 5,
(dot), then 1.
• Press RECALL to go to the previous channel.
Adjusting the volume
To adjust the volume:
• Press VOL + or VOL – to increase or decrease the
volume.
• Press MUTE to turn off the sound. Press MUTE
again to turn the sound back on.
Viewing channel information
To view channel information:
• Press INFO to view an information banner. The
information banner shows the current program
information such as channel number, video input
source, and resolution.
• Digital channel information—Displays the
channel number, station name, channel label,
broadcast program name, TV rating, signal
type, audio information, resolution, CC mode,
current time, and current program start and
end times.
• Analog channel information—Displays
channel number, channel label (if preset),
signal type, audio information, and resolution.
Using the electronic program guide (EPG)
To use the electronic program guide (EPG):
1 When watching digital programs, select the
channel you want to watch.
2 Press GUIDE. The EPG opens and shows detailed
information about the current program. The
amount and type of information depends on
the information provided by the broadcaster.
3 Press or to display information about future
programs on the selected channel.
4 Press GUIDE one or more times to close the EPG.
You can also wait 30 seconds for the EPG to
close automatically.
Note
You can press EXIT to stop the auto channel search,
but you will need to run the auto channel search
again to create a channel list.
Note
Unless otherwise noted, all tasks in this section are
based on using the remote control.
Warning
When your TV is in standby mode, it is still receiving
power. To completely disconnect power, unplug the
power cord.
Note
If your TV does not receive an input signal for several
minutes, it automatically goes into standby mode.
Source list
TV
AV
Component
VGA
HDMI 1
HDMI 2
HDMI 3
HDMI 4