Filter
Top Products
12
Insignia NS-LTDVD26-09CA 26" LCD TV/DVD Combo
www.insignia-products.com
Connecting a computer
To connect a computer using VGA:
1 Remove the port cover (1) from the back of
your TV.
2 Plug a VGA cable (4) into the VGA port on
the computer (6) and into the VGA INPUT
port on the back of your TV.
3 Plug an audio cable (5) into the audio jack on
the computer (6) and into the AUDIO VGA
INPUT port on the back of your TV.
4 Turn on your TV.
5 Press INPUT, then press / to select PC.
To connect to a computer or other HDMI
device using the HDMI jack:
1 Remove the port cover from the back of your
TV (1).
2 Plug an HDMI cable (2) into the HDMI port on
the HDMI device (3) and into the HDMI
INPUT port on the back of your TV.
3 Turn on your TV.
4 Press INPUT, then press / to select
HDMI.
Using the basic controls
Turning the TV on and off
To turn your TV on and off:
1 Press POWER on the side of your TV or on
the remote control. The POWER/STANDBY
indicator turns blue.
2 To turn off your TV, press POWER again. The
POWER/STANDBY indicator turns red.
Adjusting the volume
You can adjust the volume using the controls on
your TV's side panel or the remote control.
To adjust the volume:
1 Press VOL+ or VOL- to increase or decrease
the volume.
2 Press MUTE to mute the sound, then press
again to restore the sound.
Changing the video mode
Your TV supports multiple video modes.
To select the video mode:
• Press INPUT one or more times to select the
video mode, then press ENTER. You can
select:
• TV
•AV1
•AV2
•S-Video
• YPBPR
• DVD
• HDMI
• PC (VGA)
Using your TV
Selecting the TV signal source
To select the TV signal source:
1 Press TV MENU, then press / to
highlight the CHANNEL icon. The
CHANNEL
menu opens.
2 Press / or ENTER to enter the
CHANNEL
menu.
3 Press / to select TV Source, then press
/ to select Air or CATV.
• Air-VHF/UHF channels.
• CATV-Cable TV channels.
4 Press TV MENU one or more times to close
the menu.
Note
When the computer goes into standby mode, your
TV turns off. If your TV does not turn on when you
“wake” your computer, press POWER on your TV
or remote control.
RF INPUT
CHANNEL
TV Source
Auto Scan
Channel No.
Channel Label
Show/Hide
CATV
Hide
1
-
--- ---
Adj ExitSel
MENU
08-1156 NS-LTDVD26-09CA - combined.fm Page 12 Tuesday, April 1, 2008 1:25 PM