Filter
Top Products
FIXED-POSITION WALL MOUNT FOR TVs 19-39 in.
10
www.insigniaproducts.com
STEP 5 - Option 1: Installing on a wood stud wall*
Note: Any drywall covering the wall must not exceed 5/8 in. (16 mm).
1
Locate the stud. Verify the center of the stud with an edge-to-edge stud finder.
2
Align the wall plate template (P) at the height you determined in the previous step (or by using the
HeightFinder mentioned on the template), make sure that it is level, then tape it to the wall.
3
Drill pilot holes through the template to a depth of 3 in. (75 mm) using a 7/32 in. (5.5 mm) diameter drill
bit, then remove the template.
4
Align the wall plate (A) with the pilot holes, insert the lag bolts (S) through the lag bolt washers (R),
then through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall
plate.
CAUTION
: Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts (S).
You’ll need
A
S
R
3 in.
(75 mm)
* Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 11/2 x 31/2 in. (38 x 89 mm).
Edge-to edge
stud finder
S (2)
Drill
7/32 in. wood
drill bit
1/2 in. socket wrench
Level
R (2)
Wall plate template (P)
Tape
Wall plate (A)