Filter
Top Products
FIXED-POSITION WALL MOUNT FOR TVs 19-39 in.
11
www.insigniaproducts.com
STEP 5 - Option 2: Installing on a solid concrete or concrete
block wall*
CAUTION:
To prevent property damage or personal injury, never drill into mortar between blocks. Mount wall
plate directly onto the concrete surface.
1
Align the wall plate template (P) at the height you determined in the previous step (or by using the
HeightFinder mentioned on the template), make sure that it is level, then tape it to the wall.
2
Drill pilot holes through the template to a depth of 3 in. (75 mm) using a 3/8 in. (10 mm) diameter
masonry drill bit, then remove the template.
3
Insert the concrete wall anchors** into the pilot holes and use a hammer to make sure the anchors are
flush with the concrete surface.
4
Align the wall plate (A) with the anchors, insert the lag bolts (S) through the lag bolt washers (R), then
through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall plate.
CAUTION:
Avoid potential injuries or property damage!
DO NOT over-tighten the lag bolts (S).
**Not included. Call Customer Service to have the Fischer UX10 x 60 concrete anchor kit shipped directly to
you.
You’ll need
3 in.
(75 mm)
* Minimum solid concrete
thickness: 8 in. (203mm).
* Minimum concrete
block size: 8 x 8 x 16 in.
(203 x 203 x 406 mm).
The minimum distance
between the top two
fasteners cannot be less
than 2.865 in. (72.8 mm)
See Note**
See
Note**
** Note: Not
included. Call
Customer Service to
have the Fischer UX
10 x 60 concrete
anchor kit shipped
directly to you.
Hammer
S (3)
Drill
1/2 in. socket wrench
Level
R (3)
Wall plate template (P)
Tape
Wall plate (A)
3/8 in. masonry
drill bit