Filter
Top Products
5
CORNER TV STAND
www.insigniaproducts.com
ASSEMBLY INSTRUCTIONS
Step 1: Preparing the legs and frame.
Caution: Do not fully tighten allen bolts (L) until Step 2.
1 Screw four floor levelers (J) into the holes in the legs (A).
2 Connect the slots on the legs (A) to the slots on the frame (B), and attach using four allen screws (K) with the
allen wrench (P).
Tips:
The back side of frame (B) is labeled "Back."
The top of the legs (A) and the top of the frame (B) should be flush when the parts are connected.
3 Attach the support bar (C) to the legs using two allen bolts (L) with the allen wrench (P).
Tip: The hole in the support bar (C) should face up (see the arrow).
F
R
O
N
T
You’ll need:
4 - Allen screws (K)
2 - Allen bolts (L)
4 - Floor levelers (J)
1 - Allen wrench (P)
NS-WG1542_14-0295_MAN_V2_ENG.fm Page 5 Monday, April 28, 2014 7:32 AM