Filter
Top Products
47
SN 29343135 DPS-7.2E
■ Gain Settings
Expert
You may want to make this setting if you connected this player
to your amplifier using the 5.1 channel analog outputs.
Under the default setting, all channels are output at the
relative volumes they were recorded at. Change the setting to
[Variable] if you want to adjust the relative volume levels of
any of the speakers. Adjustment is in the range of –6dB to
+6dB, in steps of 0.5dB.
When set to [Variable], the overall output level may sound
quieter than when set to [Fix]. This is not a malfunction.
—
—
Audio2
Video1
Language
General
A1
V2
Exit
Move
SETUP
Select
ENTER
Audio Out
Speaker Setting
Gain Setting
CD Digital Direct
2 Channel
Fix
Variable
Exit
Select
Test Tone
Return
Audio2
Video1
Language
General
A1
V2
L
C
R
RS
LS
SW
Gain Setting
— 0.0 dB
— 0.0 dB
— 0.0 dB
— 0.0 dB
— 0.0 dB
— 0.0 dB
LCR
SW
LS RS
SETUPENTER
RETURN
Settings: Fix (Factory setting)
Variable
Note
Gain settings are not effective when playing a CD with CD Digital
Direct set to [On].
To help you gauge the correct gain levels, set the [Test Tone]
to [On] (test tone from just that speaker) or [Auto] (test tone
from each speaker in turn, excluding the subwoofer) then
adjust the gain so that all speakers appear to be the same
volume from your listening position.
Follow the on-screen displays to select speakers and set the
channel levels.
• You can adjust the [Test Tone] setting only when the player
is stopped.
• Many AV amplifiers allow you to make similar settings at the
amplifier stage. In this case, set the channel levels at the
player or the amplifier, not both.
• As the test tone plays through a speaker, its name is
highlighted in yellow on-screen.
■ CD Digital Direct
Expert
Setting this to On increases CD audio quality by bypassing
certain audio circuits in the player that audio signal would
otherwise pass through. However, this must be set to [Off] for
proper playback of DTS encoded CDs.
—
—
Audio2
Video1
Language
General
A1
V2
Exit
Move
Audio Out
Speaker Setting
Gain Setting
CD Digital Direct
2 Channel
Fix
On
Off
SETUP
Settings: On
Off (Factory setting)
Note
If this setting is set to [On] when a DTS CD is playback, noise is
produced.
Note
You can't use the test tone function when the Audio Out setting is 2
Channel (see page 46).The test tone will not work with the disc tray
open, or while a disc is playing.
Exit
Select
Gain
Return
Audio2
Video1
Language
General
A1
V2
L
C
R
RS
LS
SW
Test Tone
— Off
— Off
— Off
— Off
— Off
— Off
LCR
SW
LS RS
SETUPENTER
RETURN