Filter
Top Products
Masterpage:Right0
EN 59
Filename [M150SEK_10Subsidiary.fm]
SYSTEM CONNECTIONS
Connect the satellite receiver to the [L-2 IN] connector, then
connect the [L-1 IN/OUT] connector to the TV’s connector.
NOTES:
● Set AL-2 SELECTB to AVIDEO/RGBB or AS-VIDEO/RGBB.
(A pg. 58)
● You can use the Automatic Satellite Programme Recording
function with this connection. (A pg. 42)
● To record a programme via the satellite receiver, select L-2 mode
by pressing PR +/– so that AL-2B appears on the front display
panel.
● For details, refer to the instruction manual of the satellite receiver.
These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
1 Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using an optional coaxial cable.
NOTE:
For details on [DIGITAL AUDIO OUT] connector setting, refer to
ADIGITAL AUDIO OUTB. (A pg. 60)
Connecting To A Satellite Receiver
IMPORTANT
When you set AL-2 SELECTB to ASAT VIDEO/RGBB or ASAT
S-VIDEO/RGBB (A pg. 58), it is possible to view a satellite
broadcast with the TV set to an input mode such as EXT1 even if
the unit is turned off. When the unit is in Stop mode or recording,
press TV/VIDEO on the remote control to turn off the Video
indicator on the front display panel.
● If you turn on the unit when the satellite receiver’s power is off,
nothing appears on the TV screen. In this case, turn on the
satellite receiver, or set the TV to its TV mode, or slide the TV/
DVD switch to TV to set the unit to the AV mode.
Outdoor unit
Satellite cable
Satellite receiver
Aerial
TV aerial cable
ANTENNA OUT
ANTENNA IN
TV
Rear of unit
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
Dolby Digital Decoder or
amplifier with built-in DTS
Coaxial cable
(not supplied)
Rear of unit
To [DIGITAL OUT
(COAXIAL)]
To DIGITAL AUDIO
input
M150SEK_00.book Page 59 Wednesday, June 15, 2005 4:04 PM