JVC DR-MV5SEK DVR User Manual


 
Filename [MV5SEK_07Basic PlayRec.fm]
Masterpage:Left0
26 EN
Page 26Wednesday, 31 August 2005 19:58
BASIC RECORDING
1
Load a recordable disc.
For details, refer to “Placing A Disc” (pg. 9).
2
Press VHS/DVD on the unit repeatedly
or DVD on the remote control so that
the DVD lamp lights up on the unit.
3
Press PR +/– or the number buttons to
select the channel you wish to record.
If you record the programmes received by the satellite
receiver ...
1) Select “L-2” by pressing PR +/–.
2) Set the satellite receiver to the appropriate channel.
4
Press REC MODE repeatedly to select
the recording mode, then press
ENTER.
Each time you press REC MODE, the recording mode
changes as follows:
XP ] SP ] LP ] EP ] FR60–FR360* ] FR420,
FR480 ] (Back to the beginning)
* The value is selectable from 1 to 6 hours in 5-minutes interval
by pressing
we
repeatedly after selecting “FR60–FR360”. To
change the value in 30-minutes interval, press and hold
we
.
For details on the recording mode, see “Recording Mode”
(pg. 27).
5
Press 7 on the unit to start recording.
Or while holding 7, press 4 on the
remote control.
6
Press 9 to pause recording.
To resume recording, press 4.
7
Press 8 to stop recording.
It takes about 10 seconds to end the writing session when
you stop recording.
Basic Recording (DVD)
Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/DVD switch to DVD.
A
TTENTION:
It is not possible to record programmes on a DVD-R disc
which has already been finalised.
VHS/DVD
DVDVHS
REC
VHS DVDDUBBING
PR
DV IN
STANDBY/ON
S-VIDEO VIDEO AUDIO
we
DVD lamp
MV5SEK_00.book Page 26 Wednesday, August 31, 2005 7:58 PM