Filter
Top Products
Masterpage:Right+
EN 77
Filename [MV5SEK_12RemoSys.fm]
SYSTEM CONNECTIONS
Page 77 Wednesday, 31 August 2005 19:58
These instructions enable you to connect your unit to a Dolby
Digital Decoder or an amplifier with built-in DTS.
1 Connect the unit and a Dolby Digital Decoder or an amplifier
with built-in DTS using an optional coaxial cable.
NOTES:
● For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY
DIGITAL/PCM”. (੬ pg. 78)
● For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”.
(੬ pg. 78)
CAUTIONS:
● This unit has a dynamic range of more than 110 dB with regards to its
Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.
● Some speakers and televisions are specially shielded to prevent
television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.
When you can’t switch the audio channel of a bilingual
programme
When the unit is connected with a digital audio device using an
optional coaxial cable and “DIGITAL AUDIO OUT” is set to
“DOLBY DIGITAL/PCM”, it is not possible to switch the audio
channel of a bilingual programme recorded on a DVD-RAM or
DVD-RW (VR mode) disc. In this case, perform the following steps
using the remote control to switch “DIGITAL AUDIO OUT” from
“DOLBY DIGITAL/PCM” to “PCM ONLY”.
A Press SET UP to access the Main Menu screen.
B Press we to select “DVD SET UP”, then press t.
C Press we to select “AUDIO OUTPUT”, then press t.
D Press rt to select “DIGITAL AUDIO OUT”, then press
ENTER.
E Press rt to select “PCM ONLY”, then press ENTER.
(੬ pg. 78)
F Press SET UP to complete the setting.
G Press AUDIO to select the desired audio channel. (੬ pg. 50)
Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS
Dolby Digital Decoder or
amplifier with built-in DTS
To DIGITAL AUDIO input
Coaxial cable
(not provided)
Rear of unit
To [DIGITAL AUDIO
OUT (COAXIAL)]
MV5SEK_00.book Page 77 Wednesday, August 31, 2005 7:58 PM