Filter
Top Products
10
ENGLISH
Castellano
Català
First Time Installation > Language Setting
Step 1: Please choose language
Language
Deutsch
English
Suomi
Français
Svenska
First Time Installation > Country Setting
Step 2: Please choose country
Country
Finland
Germany
Spain
France
Sweden
First Time Installation > Service Scan
Step 3: Please press OK
Scan Automatic
Start Channel
_ _
Stop Channel
_ _
Mode Add
Start Scan
Service
First Time Installation > Service Scan
Step 3: Please press OK
Scan Automatic
Start Channel
_ _
Stop Channel
_ _
Mode
Add
Start Scan
Service
YLE TV1
UHF33 : 3 Services found
YLE FST
YLE TV2
Stop
Channel
_ _
Mode
Add
Start Scan
Teema
Teema
Teema
Yes No
Scan completed! Store services?
No services found!
OK
Stop Channel
Mode
Start Scan
On
Off
Antenna Power
Initial settings
Register digital / analogue channels on TV. These channels can be edited later.
(In this manual, digital terrestrial broadcasting is indicated as digital channels,
analogue terrestrial broadcasting and analogue cable TV as analogue channels.)
Begin
To the previous screen
Exit
BACK
TV/DTV
If the “JVC” logo does not appear or if you wish to
make changes later
Digital channel settings : “DTV Configuration” (P. 25)
“DTV Installation” (P. 27)
Analogue channel settings : “Set Up” (P. 22)
The remote control
doesn’t work
Confirm the mode is set to
“TV”.
Shown only when powering on for the first time.
The power button on the unit can also be used.
2
1
Set digital channels
Select a language
Select the country of installation
Scan digital channels
Register digital channels
1
2
4
5
What is “T-V LINK”?
Connecting the TV to a “T-V LINK”
compatible device allows :
Analogue channels to be instantly
registered on the device.
The “DIRECT REC” function to be
used.
“Technical information” (P. 33)
“T-V LINK” variations
“T-V LINK” (JVC) “Q-LINK” (Panasonic)
“Megalogic” (Grundig) “Data Logic” (Metz)
“SMARTLINK” (Sony) “Easy Link” (Philips)
If digital channels are not found, the following message will appear.
After completing following steps, read “When the TV cannot find the digital
channels” (P. 11) and try scanning digital channels again
Language for on-screen
displays when watching digital
channel including the DTV
menu.
!
(Next page)
3
Set the aerial power supply
Only when using an aerial which
needs external power, select “On”.
“Power supply for the indoor
aerial” (P. 33)
Receivable digital channels will
differ depending on the country
setting.
The illustrations are for Finland
1 select
2 set
1 select
2 set
1 select
2 set
When turning on the TV, it takes about
1 minute to project the picture to its full
brightness.
When turning off the TV, it takes about 5
seconds to make the screen dark. After
that, cooling is performed for about 1
minute.
“About the LAMP indicator” (P. 6)
LCT2236-001A-A.indb 10LCT2236-001A-A.indb 10 4/5/2007 10:49:26 AM4/5/2007 10:49:26 AM