Filter
Top Products
38 EN
IN F-1
+
1
POWER
TIMER ( )
TIMER RECORDING (cont.)
You can directly program the VCR’s timer to record up to
24 broadcasts, as far as a year in advance. Remember,
the clock must be set before you can program the timer
(੬ pg. 10).
1
Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape, then load it
into the VCR.
● The VCR turns on, and the counter is reset,
automatically.
2
Access VCR PLUS+ screen
Press PROGRAM.
3
Access Program screen
Press START +/– once.
4
Set program start time
Press START +/–
repeatedly to enter
the time you want
recording to start.
● Press and hold
START +/– to
increase the time in
30-minute intervals.
5
Set program stop time
Press STOP +/– repeatedly to enter the time you
want recording to stop.
● Press and hold STOP +/– to increase the time in
30-minute intervals.
6
Set program date
Press DATE +/–. (The current date is displayed on
the screen. The date you enter appears in its
place.)
7
Set channel number
Press TV/VCR CH +/–.
● If you are using a DBS receiver, see
“ATTENTION FOR DBS RECEIVER USERS” on
next page.
● Holding down TV/VCR CH +/– rapidly changes
the channel numbers.
Express Timer
Programing
VCR
TV
CABLE
/DBS
POWER
TIMER ( )
8
9
0
WEEKLY
DAILY
DBS
2
3 - 7
CONFIRM CANCEL
– –:– – AM
STD (SP)
– –/– –/– –– – –
8:00 PM
START TIME STOP TIME DATE
DAILY/WEEKLY
CH
SOURCE
TIMER PROGRAM
REC SPEED
SET PROGRAM WITH [+/–, REC SPEED
8=DAILY, 9=WEEKLY] THEN PRESS "CONFIRM"
STARTSTOP DATE CH
EXIT
PROG.
EVERY SUN
● Turn on the VCR and the TV, and select the AV
mode on the TV.
● Set the VCR/TV/CABLE/DBS selector on the
Remote to “VCR”.
HM-DH40000U-EN34-41 1/23/3, 5:22 PM38