JVC HR-J265EK VCR User Manual


 
5
ENTREE
ANT. IN
ENTREE/DECODEUR
IN/DECODER
AV2
ENTREE/SORTIE
IN/OUT
SORTIE
RF OUT
ANTENNE
AV1
AV CONNECTION
To Connect To A TV With 21-pin AV input connector
(SCART) . . .
1– Connect the aerial, recorder and TV as per “RF
CONNECTION”.
2– Connect an optional SCART cable between the AV1 IN/OUT
connector on the rear panel of the recorder and the TV’s
21-pin AV input connector (SCART).
STEP
2
INSTALLATION
CONNECT VIDEO RECORDER TO TV
Place the recorder on a stable, flat surface.
Make this
connection if
your TV has a
21-pin AV input
connector (SCART) in
order to reduce the
possibility of interference.
And if you are using a stereo
TV, you will need this cable
in order to enjoy stereo
playback of videotapes.
RF CONNECTION
To Connect To A TV With NO 21-pin AV input connector
(SCART) . . .
1– Disconnect the TV aerial cable from the TV.
2– Connect the TV aerial cable to the ANT. IN jack on the rear
panel of the recorder.
3– Connect the provided RF cable between the RF. OUT jack
on the rear panel of the recorder and the TV’s aerial
connector.
Go to Step 3 – AUTO SET UP
AFTER YOU FINISH THIS STEP
ATTENTION
Do NOT Plug the mains power cord into a mains outlet until all connections are completed.
Do NOT press the button on the recorder or on the remote control to turn on the recorder's
power before you start the Auto Set Up procedure described on page 6.
21-pin AV input connector
(SCART)
Aerial connector
Back of TV
21-pin SCART Cable
(not provided)
RF Cable (provided)
TV Aerial Cable
(not provided)
Mains Power Cord
Back of Recorder
Mains outlet