JVC HR-S5990AM VCR User Manual


 
28 EN
G-CODE/SHOWVIEW NO.
12345678
[0 – 9] =
[ ] : DELETE
[PROG] : EXIT
ACCESS G-CODE/
SHOWVIEW NO. SCREEN
1
Press PROG.
ENTER G-CODE NUMBER
2
Press the NUMBER keys to
enter the G-
CODE number
of a programme you wish
to record.
If you make a mistake,
press
and input the
correct number.
ACCESS G-CODE
PROGRAMME SCREEN
3
Press OK, and the G-CODE
Programme screen
appears. (If you're just
starting out, "P1" appears.)
IMPORTANT
Make sure the channel position number you wish
to record is displayed; if not, see "G-
CODE/SHOWVIEW
System Setup" on page 26 and set the Guide
Program number for that G-
CODE number correctly.
If the number you entered is invalid, "ERROR" appears
on the screen. Press
and input a valid G-CODE
number.
If the "G-CODE/SHOWVIEW SETUP" screen appears,
see "ATTENTION – Regarding Guide Program
Number Set" on page 29.
SET TAPE SPEED
4
Press SP/LP/EP ( ) to set the tape speed.
– P1 –
NO. 123456789
START STOP
21:00 = 22:00
SP
DATE TV PROG
25.04 1
: OK [1]: TITLE
G-
CODE
/S
HOW
V
IEW
Timer
Programming
Before performing G-CODE/SHOWVIEW Timer Programming:
Be sure to read "G-
CODE/SHOWVIEW System Setup" ( pg. 26).
Insert a cassette with the safety tab in place. The recorder
will come on automatically.
Turn on the TV and select the VIDEO channel (or AV
mode).
Select the appropriate colour system (
pg. 52).
With the G-CODE system , timer programming is greatly
simplified because each TV programme has a corresponding
code number which your recorder is able to recognise.
TIMER RECORDING (cont.)
G-CODE/SHOWVIEW NO.
[0 – 9] =
[
+/–
] : EXPRESS PROGRAMING
[PROG] : EXIT
Remember, the clock must be set before you can
programme the timer (
pg. 12).
INFORMATION
G-CODE and SHOWVIEW are different trademarks used to
represent the same easy recording feature, but only the
term G-CODE system will be used in the instructions. If you
use the S
HOWVIEW system, follow the same instructions
listed for the G-
CODE system.
OK
NUMBER
SP/LP/EP
PROG
HR-S5900/5990AM-EN26-46 5/9/02, 4:31 PM28