Filter
Top Products
EN 29
ACCESS TITLE EDIT SCREEN
5
Press the NUMBER key
“1”. The Title Edit screen
appears.
● You can access the Title
Edit screen only when
“PROG. NAVIGATION”
is set to “ON”. (੬ pg.
38)
ENTER PROGRAMME TITLE
6
Press the NUMBER keys
and PUSH JOG
#
to enter
characters, then press OK
For details, refer to
“Entering Character” on
page 41.
RETURN TO NORMAL
SCREEN
7
Press PROG or OK. "PROGRAM COMPLETED" appears
on the screen for about 5 seconds, then normal screen
appears. If “PROGRAM OVERLAPPED” appears on the
screen and “Err” on the display panel, see page 35.
● Repeat steps 1 – 7 for each additional programme.
ENGAGE RECORDER'S
TIMER MODE
8
Press
‰‰
‰‰
‰. The recorder turns off automatically and "
‰‰
‰‰
‰"
appears on the display panel.
● To disengage the timer, press
‰‰
‰‰
‰ again.
NOTES:
●
To Change The Stop Time . . .
. . . press STOP +/– after pressing OK in step 3. You can
compensate for anticipated programme schedule delays this
way.
●
To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing OK in step 3, press WEEKLY (NUMBER key
"9") for weekly serials or DAILY (NUMBER key "8") for daily
serials (Monday – Friday). Either "WEEKLY" or "DAILY"
appears on the screen. Pressing the button again makes the
corresponding indication disappear.
●
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on screen. To record the
extra programme, you must first cancel any unnecessary
programmes (
੬
pg. 34).
●
It is not possible to timer-record a TV programme with a
G-
CODE
number which starts with "0".
●
In case of a power failure after programming, the recorder's
memory backup keeps your selections (if the lithium battery is
not exhausted).
ATTENTION
Regarding Guide Program Number Set
"G-CODE/SHOWVIEW SETUP" appears after performing
step 3 if the Guide Program number for the G-
CODE number
you entered has not been set.
● Press the NUMBER keys or PUSH JOG %fi to input the
channel position number on which your recorder
receives that station, then press OK or PUSH JOG .
The G-
CODE program screen appears.
(Ex.) To timer-record a RTR
programme with the G-
CODE
system.
* If your recorder receives
RTR on the channel position
2, press OK or PUSH JOG
after entering "2".
%
%
WEEKLY
DAILY
OK
STOP+/–
PUSH JOG
NUMBER
G-CODE/SHOWVIEW SETUP
GUIDE PROG TV PROG
2– –
[0-9] OR [
5
/
∞
]:SELECT =
[PROG] : EXIT
Satellite Tuner Users
To timer-record a satellite broadcast using the G-CODE
system:
Perform steps 1 – 8.
Set the satellite tuner to the appropriate channel before
the selected programme begins.
Leave the satellite tuner's power on.
PROG
– P1 –
25.04 21:00 PR.1
[0–9] : SELECT LETTERS
[
] : DELETE
[
2
/
3
] : CURSOR+=
: OK [PROG] : EXIT
– P1 –
25.04 W
7
[0–9] : SELECT LETTERS
[
] : DELETE
[
2
/
3
] : CURSOR+=
: OK [PROG] : EXIT
HR-S5900/5990AM-EN26-46 5/9/02, 4:31 PM29