Filter
Top Products
27
– –:– –
123
456
7
89
0
2
4
1
3
ATTENTION
● Be sure not to turn on the satellite receiver before the
programme is executed; otherwise, the recorder will start
recording when the satellite receiver's power is turned on.
● If you have connected another appliance other than a
satellite receiver to the AV2 IN connector, be sure not to
engage the Auto Satellite Prog Rec mode; otherwise, the
recorder will start recording when the connected
appliance's power is turned on.
● Auto Satellite Prog recording and timer-recording cannot
be done at the same time.
● When you press and hold the recorder's REC LINK button
to engage the Auto Satellite Prog Rec mode, if the REC
LINK button does not light but instead blinks quickly even
though your satellite receiver's power is off, Auto Satellite
Prog Recording will not work properly with that satellite
receiver*.
If this is the case, perform "Express Timer Programming"
(੬ pg. 14) to timer-record a satellite programme.
*Some satellite receivers output signals even if the power is off.
Auto Satellite Prog Recording is not possible with those satellite
receivers.
Before performing the following steps:
● Make sure the satellite receiver is connected to the
recorder's AV2 IN connector. (੬ pg. 26)
● Programme the timer on the satellite receiver.
● Insert a cassette with the safety tab in place.
SET TAPE SPEED
1
Press SP/LP ( ) to set the tape speed.
ENGAGE AUTO SATELLITE
PROG REC MODE
2
Press and hold REC LINK for about 2 seconds. The
button lights up and the recorder turns off automati-
cally.
● To disengage the Auto Satellite Prog Rec mode, press
REC LINK. The light goes off.
● If the recorder's power is off, it is not possible to
engage the Auto Satellite Prog Rec mode.
NOTES:
●
Auto Satellite Prog recording is not possible with the AV1 IN/
OUT connector.
●
When the Auto Satellite Prog Rec mode is engaged or the
recorder's power is turned off after Auto Satellite Prog
recording is finished, the recorder will not enter the Timer
mode even though "AUTO TIMER" is set to "ON".
●
After Auto Satellite Prog recording, the number of recorded
programmes will not be displayed on the front display panel
for the Instant ReView function (
੬
pg. 19).
●
For timer programming of the satellite receiver, refer to the
instruction manual of the satellite receiver.
●
Auto Satellite Prog recording is not possible if your satellite
receiver does not have a timer.
●
The REC LINK button blinks while Auto Satellite Prog
recording is in progress.
●
Pressing the recorder's button while Auto Satellite Prog
recording is in progress turns off the recorder's power and
disengages the Auto Satellite Prog Rec mode.
●
If there is more than one satellite programme you wish to
record with Auto Satellite Prog Recording, it is not possible to
set a different tape speed for each; the tape speed selected in
step 1 will apply to all the programmes for Auto Satellite Prog
recording.
●
The B.E.S.T. system (
੬
pg. 22) does not work while Auto
Satellite Prog recording is in progress.
●
Just Clock (
੬
pg. 49) does not work when the Auto Satellite
Prog Rec mode is engaged.
●
Depending on the type of satellite receiver, the recorder may
not record a short portion at the beginning of the programme
or may record slightly longer than the actual length of the
programme.
●
If you engage the Auto Satellite Prog Rec mode when the
satellite receiver's power is on, the recorder will not start Auto
Satellite Prog recording even though the REC LINK button
blinks. When the satellite receiver shuts off once and is turned
back on again, the recorder starts recording.
●
You can also record a programme from your cable system in
the same way if the system has a timer and is connected to
the recorder's AV2 IN connector.
REC LINK
SP/LP