JVC HR-J267MS VCR User Manual


 
14 EN
Index Search
Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
NOTE:
Before starting, make sure the
recorder is in the Stop mode.
ACTIVATE INDEX SEARCH
1
Press PUSH JOG or ( or £) on the remote
control. " 1" or "£ 1" is displayed on screen and
search begins in the corresponding direction.
To access index codes 2 through 9, press PUSH JOG
or repeatedly until the correct index number is
displayed.
Ex.: To locate the beginning of B from the current
position, press PUSH JOG twice.
To locate the beginning of D from the current
position, press PUSH JOG once.
When the specified index code is located, playback
begins automatically.
%
%
%
Current position
AB C D E F
–2 –1 1 2 3
%
%
Index number
£
2
PLAYBACK (cont.)
12 3
4
0
6
78
5
9
1
4
3
2
FF
REW
PUSH JOG
TIMER
OK
MENU
PLAY
Repeat Playback
Your video recorder can automatically play back the whole tape
50 times repeatedly.
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT
PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
The Play indicator ( ) on the display panel blinks
slowly.
The tape plays 50 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.
PAUSE
STOP